Bitzenburger

[SpinninYote]

I was also wondering how far to the right do you set the top mark on your bitzenburger fletcher? I just bought one and am having a hard time deciding how far to move it to the right to get a 3 or 4 degree offset. Any advice would be great!
Yote

 

[coonhound40]

I don't worry about the degrees, I put as much offset as I can and still maintain total vane contact.

Coon

 

[canhunter]

Depends on the shaft diameter. Set it up and use a grease pen or pencil to draw a line. Use a protractor before or after to be dead nuts or what ever looks good. 3-4 is noticeable but not super crazy. If you can clear the rest with 4 why not go helical?

 

[BigPig]

You'll have to play with it. Crank it as far as you can while still keeping contact with the shaft, which is a bit tougher with the short Blazers. Put an arrow in the cradle and a fletch in the clamp dry. Try it out over and over a gain until you get as much turn as you can before the bottom of the fletch loses contact with the arrow.

 

[slider]

When I bought mine I called customer service and they walked me through it while I was on the phone with them!!!Give them a call!!! Good Luck

 

[SpinninYote]

Thanks for all the help. Guys like you that are positive and want to help make this site great! Thanks again
Yote